Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 86)

3.10 Device manager
74
PC Control / Touch Control
Select the RS-232/USB Box in the device manager and open the list
with the available RS-232 interfaces with [Edit]. Select the
interface to which the report is to be sent. Open the dialog with the
port parameters with [Edit] and configure these. The settings of
the interface must agree with these settings here. A description of
the parameters can be found in the online help.
3.10.13 Send messages as e-mails
If you are operating the Titrando system with the PC Control software,
you can send messages (all warnings with the symbol and error
messages with the symbol "stop" ) directly from the computer if it has
an Internet connection.
You need an 847 USB Lab Link in order to send messages as e-mail
from a Touch Control.
Configuration:
Open the menu File/Preferences....
Under E-Mail addresses, enter the Mail server and the following
e-mail addresses: e-mail address to be given as the Sender in the
e-mail (this address must have the format of an e-mail address, but
does not need to be identical to an existing e-mail account); e-mail
address of the Receiver who is to receive the messages. The Mail
server can be found in the settings of your e-mail program.
Activate the E-Mail checkbox under Send messages.
If the default settings are retained then messages will only be
sent when the system is running (BUSY), i.e. when a
determination or sample series has been started. If you also want to
send messages when no analysis is running (READY) then this
checkbox must be deactivated.