Metrohm 840 PC Control 5.0 / Touch Control - Manual (Page 190)

3.24 Manual control
178
PC Control / Touch Control
3.24.1 Measure
Select the [Measure] function in the Manual control dialog.
First select the sensor to be used for the measurement. All the
sensors defined under System/Sensors will be shown.
Select the Measuring input to which the sensor is connected.
Select the Measuring mode. The measuring modes that are suitable
for the connected sensor will be shown.
If a temperature sensor is connected then the temperature will be
measured automatically. You can also enter the temperature
manually here. This temperature is used for automatic temperature
compensation for pH measurements if no temperature sensor is
connected. This parameter is not available for the measuring mode
T (temperature).
The most important sensor data (sensor name, comment, sensor type
and, for pH and ISE electrodes, the calibration data) is shown under
[Info sensor].
Press [Start] to start the measurement. The display switches
automatically to the display of measured value.
The display of measured value shows the current measured value,
the type of temperature measurement (Pt1000, NTC or manual) and the
measuring temperature. The measurement is terminated with [Stop].