Sony Multi Interface Shoe Adapter - Manual (Page 1018)

Cha
p
te
r 22
DCU S
e
tu
p
(DCU)
1018
Serial Port Settings (Serial Port Assign Menu)
Serial Port Settings (Serial Port Assign
Menu)
To set the protocol to match a device connected to a 9-pin serial port, display
the DCU >Serial Port Assign menu.
To display the Serial Port Assign menu
In the Engineering Setup menu, select VF5 ‘DCU’ and HF5 ‘Serial Port
Assign.’
The serial port setting status appears in the status area.
Making Serial Port Settings
1
In the DCU >Serial Port Assign menu, select the target for the setting
(DCU1 or DCU2) from the <DCU Select> group.
2
Using any of the following methods, select the serial port.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) The setting value range depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
3
Using any of the following methods, select the protocol for the connected
device.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) 1. No Assign: nothing is connected to the serial port.
2. P-Bus: P-Bus device.
3. VTR: VTR
4. DDR SD9P: disk recorder (Sony disk 9-pin protocol)
5. DDR VDCP: disk recorder (video disk communication protocol)
Knob Parameter Adjustment Setting values
1 Port No Serial port
1 and upwards
a)
Knob Parameter Adjustment Setting values
2 Device Type Protocol selection
1 to 7
a)