Sony Multi Interface Shoe Adapter User Manual
Page 604
604
Control of VTRs, Extended VTRs, and Disk Recorders
Ch
apt
a) If after pressing the [SET XX] button you press the [ + / – ] button in the numeric keypad
control block, you can enter offsets from the existing setting values. Each time you press
this button, the sign of the offset cycles through the settings “ ”(absolute value)
t
“+”
t
“
–
”... , and the sign appears in the numeric keypad control block display. If there is no
existing setting value, then it is only possible to enter an absolute value, and not an offset
value.
Setting the start point, stop point, and start delay time in a menu
In the Device menu, you can set the start point, stop point, and start delay time.
1
In the Device menu, press VF3 ‘DDR/VTR’ and HF1 ‘Cueup & Play.’
The Device >DDR/VTR >Cueup & Play menu appears.
The status area shows the device number, register number, status
information, current time, start point, stop point, and start delay time.
2
Using any of the following methods, select the device.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
Carry out any of the following operations as required.
• To set the start point, press [Set] in the <Start TC> group.
• To set the stop point, press [Set] in the <Stop TC> group.
• To set the start delay time, press [Set] in the <Delay> group.
A timecode window appears.
4
Set the timecode value for the start point, stop point, or start delay time.
Note
You can enter a start delay time in the range that depends on the signal
format as follows:
00:00 to 59:nn,
where nn = (number of frames per second) – 1 frame.
5
Press [Enter].
START TC
STOP TC
(DUR
--:--:--:--
--:--:--:--
0:02:00
)
Knob
Parameter
Adjustment
Setting values
1
Dev
Device number
1 to 12