Sony Multi Interface Shoe Adapter - Manual (Page 323)

323
Copy and Swap
Chapt
er
8
Co
lor Ba
c
k
g
ro
und
s
, Cop
y
a
nd Sw
ap
, an
d Ot
her
S
e
tt
ing
s
Note
If a DME is being used on the source keyer for a copy or either keyer for a
swap, then if for example there are insufficient DME channels, or the limit on
using DME channels within an M/E bank is exceeded, it may not be possible
to select the DME.
Wipe copy and wipe swap
You can copy and swap the wipe settings between the banks.
Wipe copy and wipe swap in the independent key transition
control block
You can copy and swap the wipe settings among the keyers listed in the
following table.
DME wipe copy and DME wipe swap
You can copy and swap the DME wipe settings between the banks listed in the
following table.
Target bank Target keyer Target data
M/E-1 Keys 1 to 4 Key settings excluding the following data
items:
• Setup data
• Key snapshots
• Key memory
PGM/PST Downstream keys 1 to 4
Target bank Target data
M/E-1
PGM/PST Wipe settings.
It is not, however, possible to carry out copy or swap involving
independent key transition wipe settings.
Target bank Target keyer Target data
M/E-1 Keys 1 to 4 Wipe settings in the independent key
transition control block.
PGM/PST Downstream keys 1 to 4
Target bank Target data
M/E-1
PGM/PST DME wipe settings.
It is not, however, possible to carry out copy or swap involving
independent key transition DME wipe settings.