Sony Multi Interface Shoe Adapter - Manual (Page 842)

C
h
ap
te
r 1
8
Sy
ste
m
S
e
tu
p
(S
ys
te
m
)
842
System Settings (System Config Menu)
To select the lighting mode of the switcher bus selection buttons
on the remote panel
When switching buses with the MKS-8080/8082 AUX Bus Remote Panel or
other remote panel connected via S-Bus data link, you can select the lighting
mode of the bus selection buttons.
In the System >System Config >Panel Assign menu, select either of the
following in the <S-Bus Remote Sw'er Status> group.
Mode 1: The inhibited buttons do not light even when pressed, and the other
buttons light after a longer delay time than in Mode 2.
Mode 2: The delay time for button lighting is reduced, but even the inhibited
buttons may light for a moment when pressed.
Notes
• Make sure that [Tally Master] is set to On.
• When simple connection is used between the center control panel and remote
panel, this setting is disabled.
Specifying the DME Connected to the Switcher
1
In the System >System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
2
Using either of the following methods, select the switcher to which the
settings apply.
• In the list appearing in the menu, press the desired device name.
• Press the arrow keys to scroll the reverse video cursor.
The selected switcher appears in reverse video.
If there is only one switcher on the network, carry out the SWR1 setting
(for the first switcher) only.
3
Make the DME settings as follows.
• When making DME settings for SWR1 (the first switcher), for the
first DME, select [DME1] in the <1st DME> group.Turn all buttons in
the <2nd DME> group off.
• When making DME settings for SWR2 (the second switcher), for the
first DME, select [DME3] in the <1st DME> group. Turn all buttons in
the <2nd DME> group off.