User programmable dme in transition mode – Sony Multi Interface Shoe Adapter User Manual
Page 234
234
Overview
Ch
returning to the original image at 100%.
(Pattern number: 1701 (one-channel mode))
Defocus:
In the first half of the transition, the old video is gradually defocused,
then at the 50% point the inner image changes to the new video. In the
second half, the defocusing effect on the new video is gradually reduced,
returning to the original image at 100%.
(Pattern number: 1702 (one-channel mode))
Brick:
A brick such that the side surface is visible slides in over the old video,
then rotates so that the new video can be seen.
(Pattern numbers: 2801 to 2804, 2811 to 2814 (two-channel mode))
User programmable DME:
Using a DME keyframe effect created with a
keyframe operation, this executes a DME wipe.
Pattern numbers: 1901 to 1999 (one-channel mode), 2901 to 2999 (two-
channel mode)
For details of creating keyframe effects, see “Creating User
Programmable DME Patterns” (page 259).
In an independent key transition, you can use the following patterns. It is not
possible to use two-channel mode patterns.
User programmable DME in transition mode
For the transition mode set when creating a keyframe effect for a user
programmable DME pattern, the following can be used.
•
Single:
single transition mode
•
Flip tumble (Flip Tumble):
flip tumble transition mode
•
Dual:
dual transition mode
•
Picture-in-picture (PinP):
one-channel and two-channel picture-in-picture
transition mode
•
Compress:
a type of picture-in-picture, in which the new image is the
background, and the currently visible image shrinks, and then expands to its
original size. (See example in the next item.)
•
Frame in-out (Frame I/O):
frame in-out transition mode. When the first
transition completes, if you move the position of the image, you can move it
both horizontally and vertically.
•
Frame in-out H (Frame I/O H):
a type of frame in-out mode, which is
specified when creating a transition effect in the horizontal direction.
The image movement is reflected at both the transition start point and end
point.
(See
The operation is carried out according to DME wipe patterns 1202, 1203, or
1204.
Execution mode
DME wipe patterns that can be used
One-channel mode
Slide, squeeze, door, 2D trans, 3D trans, frame in-out, and user
programmable DME