Allied Telesis AT-S60 - Manual (Page 104)

Chapter 6: Port Parameters
Section I: Basic Features 104
Disabled - Indicates the port has been manually disabled. The port
is not able to send or receive Ethernet frames.
Link
The status of the link between the port and the end node
connected to the port. Possible values are:
Up - Indicates that a valid link exists between the port and the end
node.
Down - Indicates that the port and the end node have not
established a valid link.
Note
The link status between the port and the end node can be displayed
as “Up” even after it has been disabled in the Port Configuration
menu. For more information on how to configure a port, refer to
Configuring Port Parameters on page 106.
Neg
The status of Auto-Negotiation on the port. Possible values are:
Auto - Indicates that the port is using Auto-Negotiation to set
operating speed and duplex mode.
Manual - Indicates that the operating speed and duplex mode
have been set manually.
MDI/X
The operating configuration of the port. Possible values are Auto,
MDI, MDI-X. The Auto value indicates that the port is
automatically determining the appropriate MDI or MDI-X setting.
Speed
The operating speed of the port. Possible values are:
0010 - Indicates 10 Mbps.
0100 - Indicates 100 Mbps.
1000 - Indicates 1000 Mbps.
Duplex
The duplex mode of the port. Possible values are half-duplex and
full-duplex.
PVID
The port VLAN identifier currently assigned to the port.
Flow Ctl
The flow control setting for the port. Possible values are:
Auto - Flow control is automatically activated on the port if the
end node connected to the port uses flow control. If the end node
does not use flow control, neither does the port.