Allied Telesis AT-S60 - Manual (Page 762)

Chapter 41: Port-based VLANs
Section VI: Web Browser Management 762
Deleting a VLAN
To delete a port-based or tagged VLAN from the switch, perform the
following procedure:
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 Page is displayed with the MAC Address Tab selected
by default, as shown in Figure 212 on page 634.
3. Select the VLAN Tab.
The VLAN Tab is shown in Figure 275 on page 756.
4. In the VLANs section, click Configure.
The Port-Based VLANs Page is displayed in Figure 276 on page
757.
5. Click the circle next to the name of the VLAN you want to delete.
6. Click Remove.
A confirmation prompt is displayed.
7. Click OK to delete the VLAN or Cancel to cancel the procedure.
If you click OK, the VLAN is deleted from the switch. The untagged
ports in the VLAN are returned to the Default_VLAN as untagged
ports.
Note
You cannot delete the Default_VLAN.
8. To save your changes, return to the General Tab and click Save
Changes. The changes you made are saved on the switch.