Allied Telesis AT-S60 - Manual (Page 815)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 815
5. Configure the following parameters:
Auth Period - This is the initialization time used by the
authentication timer. The value is in seconds. The default is 30
seconds. The range is 1 to 300 seconds.
Max Start - This parameter determines the maximum number of
successive EAPOL Start messages that are sent before the
Supplicant assumes there is no Authenticator. The value is in
whole numbers. The default is 3 messages. The range is from 1 to
10 messages.
User Name - Enter a user name to access the supplicant port. The
values of Manager and Operator are not permitted. There is no
default value. This is an alphanumeric value of up to 40 characters.
Held Period - This is the initialization value for the supplicant held
timer. The value is in seconds. The default is 60 seconds. The range
is 0 to 65,535 seconds.
Start Period - This parameter provides the initialization value for
the timer that determines when EAPOL Start messages are sent.
The value is in seconds. The default is 30 seconds. The range is
from 1 to 60 seconds.
User Password - Enter a password to access the supplicant port.
There is no default value. This is an alphanumeric value of up to 40
characters.
6. Click Apply to save the settings and close the page. If you click Close,
the page is closed but the settings are not saved.
7. To save your changes, return to the General Tab and click Save
Changes.