Configuring the snmpv3 view table, Creating a view table entry – Allied Telesis AT-S60 User Manual
Page 705
AT-S60 Management Software User’s Guide
Section VI: Web Browser Management
705
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
❑ Creating a View Table Entry on page 705
❑ Deleting a View Table Entry on page 707
❑ Modifying a View Table Entry on page 708
For reference information about the SNMPv3 View Table, see
Configuring the SNMPv3 View Table on page 705.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure at the bottom of the page.
The SNMPv3 View Table Page is shown in Figure 246.
Figure 246 SNMPv3 View Table Page