Allied Telesis AT-S60 - Manual (Page 97)

AT-S60 Management Software User’s Guide
Section I: Basic Features 97
Changing the Community Status
You may want to change the status of a community to temporarily
disable a community.
To change the community status from enabled to disabled, perform the
following procedure:
1. From the Main Menu, type 5 to select System Menu.
The System Menu is shown in Figure 5 on page 51.
2. From the System Menu, type 1 to select Configure System.
The Configure System Menu is shown in Figure 11 on page 59.
3. From the Configure System Menu, type 1 to select Configure System
Software.
The Configure System Software Menu is shown in Figure 12 on
page 60.
4. From the Configure System Software Menu, type 8 to select
Configure SNMP.
The Configure SNMP Menu is shown in Figure 22 on page 87.
5. To configure SNMPv1 and SNMPv2c parameters, type 3 to select
Configure SNMPv1 & SNMPv2c Community.
The Configure SNMPv1 & SNMPv2c Community Menu is shown in
Figure 23 on page 89.
6. To modify SNMP Community attributes, type 3 to select Modify SNMP
Community.
The Modify SNMPv1 and SNMPv2c Community menu is shown in
Figure 24 on page 93.
7. To enable or disable the current community, type 4 to select Set
Community Status.
The following prompt is displayed:
Enter SNMP Community Name:
8. Enter a community name from the list at the top of the Modify
SNMPv1 and SNMPv2c Community Menu.
SNMP community names are case sensitive.
The following prompt is displayed:
Enter Community Status [E-Enable, D-Disable]:
9. Enter the status of this community.
Choose one of the following selections:
E - Select E to enable the SNMP Community.