Allied Telesis AT-S60 - Manual (Page 719)

AT-S60 Management Software User’s Guide
Section VI: Web Browser Management 719
There are four default values for this field that are reserved for
SNMPv1 and SNMPv2c implementations:
❑ defaultV1GroupReadOnly
❑ defaultV1GroupReadWrite
❑ defaultV2cGroupReadOnly
❑ defaultV2cGroupReadWrite
8. In the Storage Type field, select one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the SecurityToGroup Table to the configuration file. After
making changes to a SecurityToGroup Table entry with a Volatile
storage type, Save Changes does not appear on the General Tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the SecurityToGroup Table to the configuration file. After making
changes to a SecurityToGroup Table entry with a NonVolatile
storage type, Save Changes appears on the General Tab.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 SecurityToGroup Table entry
takes effect immediately.
9. Click Apply to update the SNMPv3 SecurityToGroup Table.
10. To save your changes, return to the General Tab and click Save
Changes.
Deleting a
SecurityToGroup
Table Entry
To delete an entry SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.