Allied Telesis AT-S60 - Manual (Page 89)

AT-S60 Management Software User’s Guide
Section I: Basic Features 89
The Configure SNMPv1 and SNMPv2c Community menu is shown
in Figure 23.
Figure 23 Configure SNMPv1 & SNMPv2c Community Menu
6. To configure SNMP parameters, type 1 to select Create SNMP
Community.
The following prompt is displayed:
Enter SNMP Community Name:
7. Enter an SNMP community name of up to 15 alphanumeric
characters. This parameter is case sensitive.
Note
Community names act as passwords for the SNMP protocol. Allied
Telesyn recommends that you select SNMP community names
carefully to ensure these names are known only to authorized
personnel.
The following prompt is displayed:
Enter Access Mode [R-Read Only, W-Read|Write]:
8. Enter an access mode for the SNMP community.
Choose one of the following:
R - Enter R to permit read only access to the SNMP community.
W - Enter W to permit read-write access to the SNMP community.
The following prompt is displayed:
Enter Open Access Status [Y-Yes, N-No]:
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
High School Switch 142
User: Manager 00:14:33 15-Jan-2004
Configure SNMPv1 & SNMPv2c Community
Community Name Access Mode Status OpenAcc Manager IP Address Trap Receiver IP
====================================================================================
ati777 Read|Write Enabled No 147.35.18.87 1.1.1.1
atipublic750 Read Only Enabled Yes 147.35.18.88 1.1.1.1
1 - Create SNMP Community
2 - Delete SNMP Community
3 - Modify SNMP Community
U - Update Display
R - Return to Previous Menu
Enter your selection?