Allied Telesis AT-S60 - Manual (Page 722)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 722
Configuring the SNMPv3 Notify Table
You can create, delete, and modify an SNMPv3 Notify Table entry. See
the following procedures:
❑ Creating a Notify Table Entry on page 722
❑ Deleting a Notify Table Entry on page 724
❑ Modifying a Notify Table Entry on page 724
For reference information about the SNMPv3 Notify Table, see
Configuring the SNMPv3 Notify Table on page 722.
Creating a
Notify Table
Entry
To create an entry in the SNMPv3 Notify Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
Notify Table. Then click Configure at the bottom of the page.
The SNMPv3 Notify Table Page is shown in Figure 255.
Figure 255 SNMPv3 Notify Table Page