Vanguard CT-7000 S3 - Manual (Page 101)

REV 1 CT-7000 S3 USER’S MANUAL
96
3.5.2. Printing a Directory of Test Plans Stored in the CT-7000 S3’s Memory
You can print a directory of all the test plans stored in the CT-7000 S3’s Flash EEPROM using the
steps below:
a. Start from the “START-UP” menu:
Press the
[4]
key (SETUP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the [3] key (PRINT PLAN DIR). The test plan directory will be printed on the built-in
thermal printer and you will be returned to the “START-UP” menu. A sample test plan
directory is shown in Figure 32.
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT PLAN DIR
4. ERASE TEST PLAN
5. SAVE TEST PLAN
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. TIME BREAKER 09/18/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS