Vanguard CT-7000 S3 - Manual (Page 26)

CT-7000 S3 USER’S MANUAL REV 1
21
3.2 Changing Setup Parameters
3.2.1. Entering Test Record Header Information
You can enter the test record header information before performing tests. The record header
includes identifying information such as the company, station, circuit, model number, etc. Once
the header information has been entered, it will apply to all subsequent test records. To enter
the header information:
a. When the unit is turned on and the firmware is loaded, you will be presented with the
“START-UP” menu as shown below:
Press the [4] key (SETUP).
b. The following screen will be displayed:
Press the [3] key (SHOT DESCRIPTION).
c. The following screen will be displayed:
Type the company name using the keypad. To erase a character at the cursor position,
press the
[CLEAR]
key. Press the
[]
key to move to the next character. Press the
[]
key to move to the previous character. Press the [ENTER] key when you are done
typing the company name.
COMPANY:
_
↑↓
to position
"ENTER" TO ACCEPT
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. TIME BREAKER 09/12/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS