Vanguard CT-7000 S3 - Manual (Page 107)

REV 1 CT-7000 S3 USER’S MANUAL
102
3.5.5. Printing a Breaker Test Plan Stored in a USB Flash Drive
Follow the steps below to print a breaker test plan stored in a USB Flash drive:
a. Make sure a USB Flash drive is connected to the unit's USB Flash drive port ("USB MEM"
port), and then start from the "START-UP" menu:
Press the
[4]
key (SETUP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the [2] key (PRINT TEST PLAN).
e. The following screen will be displayed:
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT PLAN DIR
4. ERASE TEST PLAN
5. SAVE TEST PLAN
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. TIME BREAKER 09/19/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS