InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 54)

www.infocus.com
Setting
54
In order to reduce power
consumption, some functions
in standby mode will be limited.
Under network standby, network
function is not available and
RS-232C serial communication
(except boot command) function
is not available.
• Standby mode network wake-up
function can only use the "Wake
On LAN" tool.
In order to reduce power Even
in standby mode,there are no
restraint on network function and
serial communication function.
High land
This projector provides fan control function in
the settings menu. You can change the setting
about speed of cooling fan according to the
altitude your projector is operating at.
1. Press  button to select [ High land ] menu.
2. Press <OK> button.
3. Press
 button to select required menu.
Normal speed. Set the option off
when operating the operator, if
the altitude is not too high.
Faster than when in off mode. Set
the option on when operating the
operator in high land.
Light source mode
Change lamp brightness according to the
environment and aim your projector is
operating.
1. Press  button to select [ Light source
mode ] menu.
2. Press <OK> button.
3. Press
 button to switch required menu.
Normal brightness.
Lower the brightness and reduce
energy consumption, thus
prolonging the lamp service life.
Network
Normal
Off
On
Normal
ECO
Note
• Set high land option ON when
you operate the operator at an
altitude of 1400-2000 meters.
Direct power on
Light source mode
Setting
Standby mode
High land
Cooling fast
Closed caption
Key lock
Iris
Sound
HDMI Setup
Off
Eco
Off
Normal
Off
On
High land
Setting
Standby mode
High land
Cooling fast
Closed caption
Key lock
Iris
Sound
HDMI Setup
Off
Eco
Off
Normal
Off
On
Direct power on
Light source mode
Light source mode