InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 74)

www.infocus.com
Network control
74
Network control
Network control operation
This function is designed to remote control
computer in the same LAN.
Preparation
1. Required equipment:
Projector, computer, network cable.
2. Connection:
Connect your projector to a router or switch
in the LAN with normal or jumper network
cable. In case a normal network cable failed
to connect successfully, use a jumper cable
instead.
3. Turn on the computer. The LAN port on
computer and projector are flashing after
power on the projector.
Operation steps
1. Power on your projector.
2. Acquire the IP address, with DHCP set to
on and auto IP allocation set to On. (You
may set DHCP to Off and set up IP address
manually if you are somehow familiar with
networking.)
3. Enter the network setup menu
1. Press MENU button on remote control
or top of the control panel, press 
button to select network icon.
2. Press <OK> button or  button and the
network menu displays.
3. Press  button select network
settings and press <OK> to confirm.
4. Press  button to set DHCP On and
press <OK> button to confirm
5. Press  button to select Set, press
<OK> button to wait until the “Please
wait..” message disappears.
Note
• If you are using the wireless
network connection, please
check the SSID / ESSID and
wireless IP address in the
Network Setting status, and
write down the information.
7C:6F:F8:4E:B9:2F
192.168.1.100
Expand
Network
Network setting
Network information
MAC address:
IP address
： Adjust ： Next OK ： Back MENU
LAN
DHCP
IP address
Subnet
Gateway
DNS
Network setting
Set
On
Cancel
. . .
. . .
. . .
. . .
： Adjust ： Next OK ： Back MENU
Off
192 . 168 . 1 . 100
255 . 255 . 255 . 0
192 . 168 . 1 . 1
192 . 168 . 1 . 1
LAN
DHCP
IP address
Subnet
Gateway
DNS
Network setting
Set Cancel