Ir remote signal receiver, Automatic detect 1: fixed, Heama format 1: 5-/6-bit format – Lucent Technologies MN10285K User Manual
Page 225: Pin level 1: noise filter, Positive-edge-triggered 1: negative-edge-triggered, Disable 1: enable
IR Remote Signal Receiver
IR Remote Signal Receiver Control Registers
Panasonic Semiconductor Development Company
MN102H75K/F75K/85K/F85K LSI User Manual
224
Panasonic
All registers in RMC block cannot be written by byte (by word only). Read by
byte is possible.
RMIR: Remote Signal Interrupt Control Register
x’007EA2’
RMIR controls the operating modes and interrupt operations for the
receiver circuit. It is a 16-bit access register.
MODAUTO: Automatic operating mode detection on/off
0: Automatic detect
1: Fixed
MODSEL: Operating mode select
0: HEAMA format
1: 5-/6-bit format
FILTRE: Noise filter input multiplexer on/off
0: Pin level
1: Noise filter
POLSEL: Input polarity
0: Positive-edge-triggered
1: Negative-edge-triggered
LEADERE: Interrupt enable for leader detection
0: Disable
1: Enable
TRAILRE: Interrupt enable for trailer detection
0: Disable
1: Enable
DAT8E: Interrupt enable for 8-bit data reception detection
0: Disable
1: Enable
EDMEE: Interrupt enable for RMIN pin edge detection
0: Disable
1: Enable
Bit:
7
6
5
4
3
2
1
0
MOD
AUTO
MOD
SEL
FILTR
E
POL
SEL
LEADER
E
TRAILR
E
DAT8
E
EDME
E
Reset:
0
0
0
0
0
0
0
0
R/W:
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W