NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 265)

4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Multicast > IGMP Snooping > Querier Configuration.
The Querier Configuration page displays.
6. Select the Querier Admin Mode Enable or Disable radio button to specify if IGMP
snooping is enabled for the switch.
The default is Disable.
7. In the Snooping Querier IP Address field, specify the snooping querier IP address
that must be used as the source address in periodic IGMP queries.
This address is used when no address is configured on the VLAN on which queries
are sent.
8. In the IGMP Version field, specify the IGMP protocol version used in periodic IGMP
queries.
The version can be 1 to 2. The default is 2.
9. In the Query Interval (secs) field, specify the period in seconds between periodic
queries sent by the snooping querier.
The range is from 1 to 1800 seconds. The default is 60 seconds.
10. In the Querier Expiry Interval (secs) field, specify the period in seconds after which
the last querier information is removed.
The range is from 60 to 300 seconds. The default is 180 seconds.
11. Click the Apply button.
Your settings are saved.
The page displays the VLAN IDs enabled for IGMP snooping querier.
12. To save the settings to the running configuration, click the Save icon.
Configure an IGMP snooping querier for a VLAN
You can configure an IGMP querier for use with a VLAN on the network.
Main User Manual 265 Configure Switching Information
AV Line of Fully Managed Switches M4250 Series Main User Manual