Yaskawa Σ-V Series AC Servo Drives Rotational Motor MECHATROLINK-III - Manual (Page 238)

6.17 Software Reset (Fn030)
6-39
6
Utili
ty Fu
ncti
ons (Fn
)
5. After the software reset has been completed, the following message will appear.
The message will tell you to reconnect SigmaWin+ to the SERVOPACK after the reset has been com-
pleted.
6. Click OK to close the Software Reset box.
All settings including parameters have been re-calculated. Disconnect SigmaWin+ from the SERVO-
PACK, and then reconnect to validate the new settings.
MECHA