Elektron Monomachine - Manual (Page 58)

THE PATTERN SEQUENCER
50
STEP RECORDING
The third method of recording notes differs a bit from the other two methods as data is input
on a step by step basis. You can input notes from the keyboard and the [TRIG] keys
1. Begin with following the instruction in section “RECORDING PREPARATIONS”, on
page 47.
2. To enter STEP RECORDING mode, press [REC] and [STOP] at the same time.
3. The pattern will start on the first step of the sequencer. From here the active position will
automatically advance one step forward when a note or chord is programmed.
4. You can use the [LEFT] and [RIGHT] keys to move the editing focus of the pattern.
Press the [EXIT/NO] key to program a NOTE OFF, press [ENTER/YES] to clear a note.
• Use the step recording method as an experimental way of creating patterns. Inter-
esting results can be had!
NOTE COPY
It is possible to copy a note trig, complete with all parameter lock settings, and paste it to a
new location in the track.
1. Make sure you are in GRID RECORDING mode, indicated by the <RECORD> LED giv-
ing off a steady light.
2. Press and hold the note trig you want to copy and press the [RECORD] key. A message
“COPY NOTE” will appear.
3. Hold the [TRIG] key correspondning to the location you want to paste the note to and
press the [STOP] key to complete the paste operation. A message “PASTE NOTE” will
be shown.
CLEAR NOTE PARAMETER LOCKS
Instead of removing the parameter locks from a note you can also use the clear note locks
command.
1. Make sure you are in GRID RECORDING mode. The <RECORD> LED should be lit.