Track copy, Track copy -52 – Elektron Monomachine User Manual
Page 60
THE PATTERN SEQUENCER
52
1.
Make sure you are in GRID RECORDING mode.
2.
When you are on the track you wish to clear, press and hold [SCALE SETUP]. Then
press [PLAY] to clear the track. The message “CLEAR PAGE” will appear.
•
The clear track page operation can be undone by holding the [SCALE KEY] and
pressing the [PLAY] key directly after the clear operation. The message “UNDO
PAGE” will be shown in the display.
TRACK COPY
In GRID RECORDING mode, it is possible to copy the contents of one track to another.
1.
Make sure you are in GRID RECORDING mode, indicated by the <RECORD> LED giv-
ing off a steady light. Select the source track pressing the appropriate [TRACK] key.
2.
Press [REC] while holding [FUNCTION] to copy the data of the track.The message
“COPY TRACK” will be shown in the display.
3.
Select the destination track using the [TRACK] wheel.
4.
Paste the data by pressing and holding [FUNCTION] and then pressing the [STOP] key.
A message saying “PASTE TRACK” will be shown in the display.
•
The track data copied consists of notes, parameter locks, the machine selection,
DATA pages and arpeggiator, transpose, swing and slide settings.
•
Pasting data into a track overwrites any previous notes, data and parameter locks.
•
The paste track operation can be undone by holding down the [FUNCTION] key
while pressing the [STOP] key. A message saying “UNDO TRACK” will be shown
in the display.