Elektron Monomachine - Manual (Page 93)

MONOMACHINE ROUTING
85
In the example above the two first tracks are sent on the AB bus, and are thus effected by
the FX machine on track 3. Track 4 and 5 are sent to the CD mix bus. Track 6 is an FX
machine with input taken from the CD Mix bus, which now contains the mixed signal of
track 4 and 5. The output of the FX machine on track 6 is set to bus AB with differs from the
input CD. Therefore the effected track 4 and 5 is effected and sent to mix bus AB, where
they are mixed with the Track 1 and 2 effected by track 3.
ROUTING MODE AB=MIX
By default the mix buses are sent to the audio outputs with the same names. If you are
using only the main AB stereo outputs, or the headphones which carry the same signal,
you will not hear what is sent to the CD and EF outputs. By setting the global routing (see
section “ROUTING”, on page 89) to “3xSTEREO + AB=MIX” the CD and EF buses will be
added to the stereo main AB/headphone outputs.
ROUTING MODE 6xMONO
By setting the global routing (see section “ROUTING”, on page 89) to “6xMONO”, the AB,
CD and EF mix buses will not be sent to the audio outputs. Instead, each of the stereo out-
puts of the six Monomachine tracks are mixed to mono, and fed to an individual output. The
mix buses can still be used, but the final output of them will not be sent to the AB, CD and
EF outputs.
Using this mode makes it possible to get the output of each of the Monomachine tracks
sent to an individual output, but the stereo effects and panning are lost.
4:/5)&4*4
4:/5)&4*4
4:/5)&4*4
4:/5)&4*4
'9
#64
"#
5'9
5'9
5'9
5'9
5'9
'9
#64
$%
5'9
.*9 .*9 .*9