IDEC FL1E SmartRelay - Manual (Page 108)

Programming IDEC SmartRelay
94 IDEC SmartRelay Manual 
3.6.10 Correcting programming errors
Programming errors can be corrected easily in IDEC
SmartRelay :
• Provided editing mode is not yet closed, you can revert by
one step by pressing ESC.
• If you have already configured all inputs, simply
reconfigure the faulty input:
1. Move the cursor to the faulty position
2. Change to editing mode. Press OK
3. Enter the correct input circuit
You can only replace a block with a block that has exactly the
same number of inputs. However, you can delete the old block
and then insert a new one. You can choose any new block.
3.6.11 Selecting analog output values for RUN/STOP
transition
You can select the analog values that are output at the two
analog outputs when IDEC SmartRelay changes from RUN
mode to STOP mode.
In the programming menu:
1. Move the “>” cursor to ’Edit..’: Press or
2. Select ’Edit’: Press OK
3. Move the “>” cursor to ’AQ’: Press or
4. Select ’AQ’: Press OK
5. Move the “>” cursor to ’AQ in Stop’: Press or
6. Select ’AQ in Stop’: Press OK
IDEC SmartRelay shows the following display:
>Defined
Last
AQ in Stop
Last
The first two rows show your choices. The bottom row shows
the current setting for the analog output channels. The
default setting is ’Last’.
You can select either ’Defined’ or ’Last’. ’Last’ means that the
analog output values are held at their last value and ’Defined’
means that the analog output values are set to specific
values. When IDEC SmartRelay changes from RUN mode to
STOP mode, the values of the analog outputs change as
well, depending on the setting.
7. Select the desired output setting:
Press or .
8. Confirm your entry: Press OK