IDEC FL1E SmartRelay - Manual (Page 81)

Programming IDEC SmartRelay
IDEC SmartRelay Manual 67
Rule 3
Cursor and cursor movement
The following applies when you edit a circuit program:
• You can move the cursor when it appears in the form of
an underscore:
- Press , , or to move the cursor in the circuit
program.
- Press OK to change to ”Select connector/block”.
- Press ESC to exit programming mode.
• You select a connector/block
when the cursor appears as a solid square
- Press or to select a connector or a block.
- Confirm with OK.
- Press ESC to return to the previous step.
Rule 4
Planning
• Before you start to create a circuit program, you should
either first create a design on paper or program IDEC
SmartRelay directly using WindLGC.
• IDEC SmartRelay can only save complete and faultless
circuit programs.