Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner - Manual (Page 137)

Granit XP User Guide 121
Chart, beginning on page 289. For example, 50 characters is entered as
0050 .
Note: 9999 indicates all lengths.
Step 6. Editor Commands
Refer to Data Format Editor Commands (page 122). Scan the symbols
that represent the command you want to enter.
Step 7. Scan Save to save your data format, or Discard to exit without saving your
changes.
Other Programming Selections
• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary
format, scan
0 from the Programming Chart, beginning on page 289. If you are
clearing an alternate format, scan 1, 2 , or 3 , depending on the format you are
clearing. Scan the Terminal Type and Code I.D. (see Symbology Charts on page
277), and the barcode data length for the specific data format that you want to
delete. All other formats remain unaffected.
• Clear all Data Formats
This clears all data formats.
• Save
Exit and save your data format changes.
• Discard
Exit without saving any data format changes.
Enter Data Format
Save
Discard
Clear One Data Format
Clear All Data Formats