Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner - Manual (Page 65)

Granit XP User Guide 49
Reset Scanner
Scanning this barcode reboots the scanner and causes it to relink with the base or
Access Point.
Base Charge Modes
When the base has both an external power supply (plugged into the auxiliary power
port) and a host interface cable, it will draw its power from the external power sup-
ply. When the base does not have an external power supply, it draws its power from
the interface cable. However, the scanner charges more slowly from a host inter-
face cable than if auxiliary power were available. Using the following selections,
you can specify whether the scanner is charged from power supplied via the host
interface cable.
When Base Charge Off is selected, the scanner does not charge when the scanner
is in the base cradle.
When External or Interface Cable Power is selected, the scanner charges from the
base’s external power supply, if there is one. If there is no external power supply to
the base, the scanner charges from the interface cable.
When External Power Only is selected, the scanner only charges from the base’s
external power supply. If there is no external power supply, the scanner does not
charge.
Default = External or Interface Cable Power.
Red 3 sets of flashes, repeatedly
every 3 seconds No Beep <5%
Red 20 sets of rapid flashes No Beep <2%
Scanner LED Scanner Beep Charge Level
Reset Scanner
Base Charge Off
* External or Interface
Cable Power
External Power Only