Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner - Manual (Page 178)

162 Granit XP User Guide
below, then setting the timeout (from 0-120 milliseconds) by scanning digits from
the
Programming Chart, beginning on page 289 of this manual, then Save . Default
= 500.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
Coupon GS1 DataBar Output
If you scan coupons that have both UPC and GS1 Databar codes, you may wish to
scan and output only the data from the GS1 Databar code. Scan the
GS1 Output
On code below to scan and output only the GS1 Databar code data. Default = GS1
Output Off.
UPC-E0
<Default All UPC-E Settings>
UPC-E0 On/Off
Most U.P.C. barcodes lead with the 0 number system. To read these codes, use the
UPC-E0 On selection. If you need to read codes that lead with the 1 number sys-
tem, use UPC-E1 (page 165). Default = On.
Addenda Timeout
* GS1 Output Off
GS1 Output On
* UPC-E0 On
UPC-E0 Off