Honeywell Granit 1991iSR Ultra-Rugged Standard-Range Barcode Scanner - Manual (Page 175)

Granit XP User Guide 159
UPC-A
<Default All UPC-A Settings>
UPC-A On/Off
Note: To convert UPC-A barcodes to EAN-13, see Convert UPC-A to EAN-13 on page 166.
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted
at the end of the scanned data or not.
Default = On .
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the begin-
ning of the scanned data, but can be programmed so it is not transmitted (
Off ).
Default = On.
* On
Off
* On
Off
* On
Off