LSC Lighting CLARITY LX Series v.1 - Manual (Page 207)

Clarity Intensity Levels Window
Operator Manual
Page 197
29 Intensity Levels
29.1 OVERVIEW
The Intensity Levels view complements the normal Levels views by providing intensity specific
information with optional auto-compression (hiding levels that are at zero). This makes it much
easier to see all of the channels in use when there a large quantity of fixtures. The window
provides two default views:
 “Console” which (by default) shows the source of each fixtures level and hides zero
levels.
 “Follow” which (by default) follows the current cue-list and shows its contents.
You can open “New” windows and set them to show either of the above views and also
customize their settings to your requirements as described below. Views can be undocked and
dragged onto other monitors.
29.2 VIEW SETINGS
To configure an intensity view on the Intensity Levels tool bar click Settings or right click on a
view and click “Configure”.
The options for each view are:
View Mode:
If you are configuring a new window you can set it to display either:
 Playback contents (with additional options to follow current playback, follow current cue
and show fader level of the playback).
 Console Output.
Values: (only for playback contents mode)
 Stored values only. Always display the values stored in the current cue, irrespective of
whether the cue is active or under edit.
 Stored values or edit session. Same as above but channels being edited are shown in
red.
 Live values. Only values from the current cue are shown if they are active.
Zero levels:
 Show zero levels. All levels are shown.
 Hide zero levels. Zero levels are removed from the view and all non-zero levels shuffled
up to avoid empty space.
 Shade zero levels. This also hides zero levels by making them appear very faint, but
doesn’t shuffle non-zero levels so all channels always appear in the same place.