Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) User Manual
Page 10
IQOYA SERV/LINK user manual
In order to guarantee compliance with the above standards in an installation, the following must be done:
●
the provided cables must not be modified.
●
additional cables used must have their respective shield connected to each extremity.
●
Attach a ground wire to the chassis (ideally the ground wire has a ring terminal). Connect the other end of the ground wire to a good electrical
ground point.
The limits specified in the standards are designed to provide reasonable protection against harmful interference in an industrial installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
●
reorient or relocate the receiving antenna.
●
increase the separation between the equipment and the receiver.
●
connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
consult the dealer or an experienced audio/television technician for help.
Note
:
Connecting this device to peripheral devices that do not comply with CLASS A requirements or using an unshielded peripheral data cable could also result
in harmful interference to radio or television reception. The user is cautioned that any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. To ensure that the use of this product does not contribute to
interference, it is necessary to use shielded I/O cables.
Copyright 2015 - Digigram. All rights reserved.
No portion of this manual may be reproduced without prior written consent from Digigram. The copyright protection claimed here includes photocopying,
translation and/or reformatting of the information contained in this manual.
While every effort has been made to ensure accuracy, Digigram is not responsible for errors, omissions or typos, and reserves the right to make
improvements or changes in the products and programs described without notice.
Digigram and the Digigram logo, visiblu and the visiblu logo, and IQOYA are registered trademarks or trademarks of Digigram S.A.. HE-AAC and
AAC-(E)LD are registered trademarks or trademarks of Fraunhofer IIS. All other trademarks are property of their respective holders.
You have just acquired a Digigram IQOYA SERV/LINK and we congratulate you!
IQOYA SERV/LINK is a multi channel IP audio codecs of the IQOYA range based on Digigram FluidIP
technology.
The manual at hand will guide through installation, configuration, and operation. For any software related issue,
please refer to the specific documentation provided in its online help.
10
RoHS
European directive aka “RoHS”
Note: to comply with standard EN55024, use shielded network
cables!