2 preferences −> network −> vlan – Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) User Manual

Page 45

Advertising
background image

IQOYA SERV/LINK user manual

45

8.1.3.2 Preferences −> Network −> VLAN

This page allows declaring VLANs on the Eth interfaces. No VLAN is declared by default.

Parameter

Type

Description

Internet interface name

Read

Displays the name of the Eth port

Status

Read/Write

This parameter allows enabling/disabling the interface

Default value=Running

Possible values:

Running: Eth port is enabled.

Stopped; Eth port is disabled

Speed and duplex mode obtained

Read

Displays the current speed and mode of the Eth interface.

Speed and duplex mode asked

Read/Write

Allows selecting the working mode of the Eth interface. Possible values are as
follows:

We recommended avoiding the “Auto-negotiation” mode. Select the mode supporte
by the network node connected to the IQOYA.

DHCP

Read/Write

Allows enabling/disabling DHCP (Dynamic Host Configuration Protocol). Default
value is OFF (disabled).

Click on “On” to enable DHCP. This mode disables the following parameters.

IPv4 address

Read if DHCP is On

Write if DHCP is Off

DHCP Off:

Default value is 192.168.0.100 for Eth0, and 192.168.1.100 for Eth1.

Enter the IP address of this Eth interface.

DHCP On:

Displays the IP address automatically set through DHCP.

Subnet mask

Read if DHCP is On

Write if DHCP is Off

DHCP Off:

Enter the mask of the subnet this Eth port belongs to.

DHCP On:

Displays the subnet mask automatically set through DHCP.

Gateway

Read if DHCP is On

Write if DHCP is Off

DHCP Off:

Enter the gateway IP address. Streams sent through this interface will g

through this gateway.

DHCP On:

Displays the gateway IP address automatically set through DHCP.

Primary DNS

Read if DHCP is On

Write if DHCP is Off

DHCP Off:

Enter the IP address of the used DNS (if any).

DHCP On:

Displays the IP address of the DNS set through DHCP.

Secondary DNS

Read if DHCP is On

Write if DHCP is Off

DHCP Off:

Enter the IP address of the secondary DNS (if any).

DHCP On:

Displays the IP address of the secondary DNS set through DHCP.

Advertising