Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 147)

IQOYA SERV/LINK user manual
⚠
Once the configuration is complete and the HA service is active, it is recommended to use the floating IP
address to connect to the configuration Web GUI of the HA pair. If you connect to the configuration Web GUI of the
standby device (using the IP address of its audio network interface) you will get the message “This is the standby
device. Please connect to the active device to change the configuration”.
When a device is in standby mode, its configuration cannot be changed, and some menus are no longer accessible from its
WEB pages, as shown in the following screen capture.
147
Floating IP
address This is the virtual IP address thanks to which the
pair of devices is seen from the audio network
perspective as a single device. Any valid unicast IP
address which is not
used by another
device on the
network. ∅
ID Value which identifies a HA service used by a pair
of devices.. In case several pairs of devices run
with the HA service, each HA service must be
configured with a unique ID. From 1 to 256 No default value.
Value to be
entered.
Election of
the active
device If equal to “Preferably active”, the device from
which you configure the High Availability service
will always try to get the active role. This means
that if it fails, the other device becomes Active,
and when it is connected again it becomes Active
and the other device goes back to Standby mode.
If equal to “No device has priority”, the role of the
devices will change only in case of an outage of
the active device.
No device has
priority/Preferably
active No device has
priority
SNMP If set to Yes, all the above variables can be read
from an SNMP GET command, and trap is
enabled. Make sure the SNMP service is correctly
configured. Yes - No No