Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) User Manual
Page 61
IQOYA SERV/LINK user manual
61
To edit an existing Program, click on the icon
in the left side of the Program line.
A new program can be created by duplicating one of the displayed programs; click on the icon
in front of the
program to be duplicated.
Silence detection parameters
Click on the “Silence detection” tab to set the criteria for silence detection on this program. An alarm is signalled
when silence is detected, and it is reset when signal is detected again.
It is also possible to automatically stop/start the streaming upon silence/signal detection. This can be configured
from the IP Service page (see next paragraph
Send −> IP services)
.
Give a unique name to the program.
Click on “Save” to confirm the parameters.
Click on “Close” to discard the changes.
Click on “Save & New” to confirm the settings,and
duplicate
them so that to create a new program with similar
settings, except the name.
Parameter
Type
Description
Name
Read/Write
Name given to the encoding instance. This name will be selected
when declaring an IP service.
Input type
Read/Write
Audio source of the program: it can be an audio input, or an audio
bus.
First channel
Read/Write
First input channel of the audio signal to be encoded, to be
selected among the list of input channels.
Mode
Read/Write
Mono, Stereo, Multi-channel 5.1
Sample rate
Read/Write
Frequency of the encoded audio, to be selected from the list box.
It may be different from the IQOYA sampling frequency.
Encoding format
Read/Write
Audio format of the encoding, to be selected from the list box.
Bit rate
Read/Write
Bit rate of the encoded audio.