Digigram Software for IQOYA SERV/LINK 88 (Upgrades from 8 Codecs to 16) - Manual (Page 156)

IQOYA SERV/LINK user manual
● All the lines of the log file were not displayed on the WEB page. Fixed.
The first 1000 lines are now displayed. When scrolling to the bottom, the next 1000 lines are loaded, etc...
Note: It is recommended to disable the auto refresh function when scrolling
● When enabling the GPIO’s from the WEB GUI on a SERV/LINK unit which does not feature the hardware GPIO
option, the WEB GUI hangs. Fixed.
● When enabling the GPIO’s from the WEB GUI (GPIO activation - Enabled), the field "GPI transmission mode" was
displayed empty once the configuration is validated. Fixed.
● In addition, if the mode "GPO reset value mode" is set to "custom values", the fields allowing the value selection are
not displayed. Fixed.
● In dual streaming mode, the FEC payload type was limited to values <99 instead of 128. Fixed.
16.4.2 Contribution Mode
Fixed issues
● Error when starting a configuration with 32 codecs.
● IN symmetrical RTP mode with FEC, there was an error on the UDP port number used to send back an FEC stream.
Fixed.
● Hangup does not work when the codec is called with a phone through an OVH SIP trunk
16.5 Firmware v03.01b007- December 2019
IMPORTANT
Upgrading to this firmware version is a two-step process:
1. Upgrading to an intermediate v2.19d002 firmware
2. Upgrading to the final v03.01b007 firmware
Once version 03.01b007 is installed on the unit, the rollback to a previous version is not possible.
16.5.1 What’s new since 2.19
● Possibility to run the firmware in distribution mode (only mode of previous firmware versions) or in remote
broadcasting mode (point to point full duplex connections through SIP, unregistered SIP, or symmetric
RTP). Selectable form the WEB GUI.
16.5.2 Fixed issues
● Power led was remaining on after power off.
● False hardware alarms regarding power, fans and temperature.
156