Vivotek S Series IZ9361-EH 1080p Outdoor Network Bullet Camera with Heater - Manual (Page 309)

VIVOTEK
User's Manual - 309
© 2020 VIVOTEK INC. All Right Reserved
154
PARAMETER VALUE SECURITY
(get/set) DESCRIPTION
zoommodule <boolean> 0/7 Indicate whether to support zoom lens.
In our product, only SD series and IZ
series use the zoom lens.
* Both varifocal and zoom lenses are
built with movable elements that
permit changing the effective focal
length. And the key difference between
a varifocal and a zoom lens can be
explained by thinking about a lens that
has been focused on an object at any
focal length. A varifocal will need to be
refocused whenever the focal length is
adjusted; the zoom will stay in focus
when the focal length is adjusted.
focusmode auto,onetimeauto,sp
otlight,manual
<product
dependent>
0/7 Focus mode selection:
"auto" : Camera will automatically
adjust the focus position full time to
adapt a clear picture.
"onetimeauto" : Camera will
automatically adjust the focus position
one time, which follows any PTZ
control.
"spotlight" : Camera will automatically
adjust the focus position full time, and
to consider a spotlight avoidance
situation.
"manual" : Turn off the automatically
focus function. For user to control the
focus position manually as their
purpose.
* Only available when
"capability_camctrl_c<0~(n-1)_zoommo
dule" is 1.
* We support this parameter when the
version number (httpversion) is equal or
greater than 0304a.
© 2020 VIVOTEK INC. All Right Reserved
155
7.27.2 Capability for PTZ
Group: capability_ptz_c<0~(n-1)> n denotes the value of "capability_nvideoin"
(capability_ptzenabled > 0 and capability_camctrl_c<0~(n-1)>_zoommodule !=0)
* We support this group when the version number (httpversion) is equal or greater than 0303b.
PARAMETER VALUE SECURITY
(get/set) DESCRIPTION
panspeedlv 0, <positive integer> 0/7 The maximum speed level of pan
motion.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
minpan 0, <positive integer> 0/7 The lower limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
maxpan 0, <positive integer> 0/7 The upper limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
minpanangle <integer> 0/7 The lower limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
maxpanangle <integer> 0/7 The upper limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
tiltspeedlv 0, <positive integer> 0/7 The maximum speed level of tilt
motion.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
mintilt 0, <positive integer> 0/7 The lower limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"