Vivotek S Series IZ9361-EH 1080p Outdoor Network Bullet Camera with Heater - Manual (Page 423)

VIVOTEK
User's Manual - 423
© 2020 VIVOTEK INC. All Right Reserved
268
PARAMETER VALUE DESCRIPTION
function focus,
auto,
scan,
stop,
positioning,
irisopen,
irisenable,
resetfocus
focus – Move focus motor
auto – Perform auto focus
scan – Perform focus scan
stop – Stop current operation
positioning – Position the motors
resetfocus – reset focus position to default
irisopen – Fully open iris. It will maintain fully open iris
status until sending function=irisenable cgi.
irisenable – return back to user setting status of iris.
direction direct,
forward,
backward
Motor’s moving direction.
It works only if function= focus.
position <motor_start> ~
<motor_end> Motor’s position.
It works only if function=focus and direction=direct.
<motor_start> : remote_focus_zoom_motor_start or
remote_focus_focus_motor_start,
<motor_end> : remote_focus_zoom_motor_end or
remote_focus_focus_motor_end replied from
"function=getstatus"
steps 1 ~ 30 Motor’s moving steps.
It works only if function=focus and direction=forward or
direction=backward.
* Motor will stop when it reaches to <motor_start> or
<motor_end>.
* This parameter is for additional fine-tune, the value is from 1
to 30.
iris N/A Open iris or not.
It works only if function=auto or function=scan.
Syntax:
(for query API)
http://< servername >/cgi-bin/admin/remotefocus.cgi?channel=<value>&[function=<value>]
© 2020 VIVOTEK INC. All Right Reserved
269
function getstatus Information of motors, return value as below:
remote_focus_focus_motor_max : Maximum steps of
focus motor
remote_focus_focus_motor_start : Start point of
effective focal length
remote_focus_focus_motor_end : End point of effective
focal length
remote_focus_focus_motor : Current position of focus
motor
remote_focus_focus_enable : Current function of focus
motor
remote_focus_iris_open : The current status of iris. 0:
irisenable, 1: irisopen
Current function of zoom/focus motor, return value as
below:
0: no service
1: zooming
2. focusing
3: auto focus
4: focus scan
5: positioning (both zoom motor and focus motor)
12: reset focus
8.21 Export Files
Note: This request requires Administrator privileges.
Method: GET
Syntax:
For daylight saving time configuration file:
* This CGI is not supported when the version number (httpversion) is equal or greater than 0314b,
please use “system_tz” as a replacement.
http://< servername >/cgi-bin/admin/exportDst.cgi
For language file:
http://<
servername >/cgi-bin/admin/export_language.cgi?currentlanguage=<value>
PARAMETER
VALUE DESCRIPTION