Vivotek S Series IZ9361-EH 1080p Outdoor Network Bullet Camera with Heater - Manual (Page 421)

VIVOTEK
User's Manual - 421
© 2020 VIVOTEK INC. All Right Reserved
266
PARAMETER VALUE DESCRIPTION
position <motor_start> ~
<motor_end> Motor’s position.
It works only if function=zoom or function= focus and
direction=direct.
<motor_start> : remote_focus_zoom_motor_start or
remote_focus_focus_motor_start,
<motor_end> : remote_focus_zoom_motor_end or
remote_focus_focus_motor_end replied from
"function=getstatus"
steps 1 ~ 30 Motor’s moving steps.
It works only if function=zoom or function=focus and
direction=forward and direction=backward.
* Motor will stop when it reaches to <motor_start> or
<motor_end>.
* This parameter is for additional fine-tune, the value is
from 1 to 30.
iris N/A Open iris or not.
It works only if function=auto or function=scan.
Syntax:
(for query API)
http://< servername >/cgi-bin/admin/remotefocus.cgi?channel=<value>&[function=<value>]
© 2020 VIVOTEK INC. All Right Reserved
267
function getstatus Information of motors, return value as below:
remote_focus_zoom_motor_max : Maximum steps of zoom
motor
remote_focus_focus_motor_max : Maximum steps of focus
motor
remote_focus_zoom_motor_start : Start point of zoom motor
remote_focus_zoom_motor_end : End point of zoom motor
remote_focus_focus_motor_start : Start point of effective focal
length
remote_focus_focus_motor_end : End point of effective focal
length
remote_focus_zoom_motor : Current position of zoom motor
remote_focus_focus_motor : Current position of focus motor
remote_focus_zoom_enable : Current function of zoom motor
remote_focus_focus_enable : Current function of focus motor
remote_focus_iris_open : The current status of iris. 0: irisenable,
1: irisopen
Current function of zoom/focus motor, return value as below:
0: no service
1: zooming
2. focusing
3: auto focus
4: focus scan
5: positioning (both zoom motor and focus motor)
12: reset focus
8.20 BackFocus (capability_image_c<0~(n-1)>_remotefocus=4)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
(for control API)
http://< servername >/cgi-bin/admin/remotefocus.cgi?channel=<value>&[function=<value>][&direct
ion=<value>][&position=<value>][&steps=<value>][&iris]
PARAMETER VALUE
DESCRIPTION
channel 0~"capability_nvideoin"-1 Channel of the video source.