Selecting a file to view, Logged survey data window – NARDA 8718B User Manual
Page 111
110
Operating the Meter
Three sample files were loaded on your hard drive when
installed the User’s Software. There is a sample for each of the
three modes of data logging.
Selecting a File to View
To view stored surveys on your computer...
1. Select View Stored Surveys from the Survey Data
menu. A dialog box will appear titled Open Survey File.
Normal downloaded survey files stored on the
computer’s hard drive will be listed in the table on the
left. Downloaded survey files are stored in a
subdirectory labeled Svy. You can change drives, select
which types of files are listed, or change directories from
this box.
2. Select the data file you want to view from the list of files
by either double clicking on it or highlighting it and
choosing OK.
3. A new window labeled Logged Survey Data will
appear. The file name will be shown to the right at the
top of the window.
Logged Survey Data Window
The Logged Survey Data window is comprised of two parts:
1) The header section at the top of the window defines the
equipment that was used to make the survey.
a) The first line shows the meter model number, serial
number, Cal. Date, and calibration Due date.
b) The model number, serial number, Cal. Date, and
calibration Due date of the probe used are shown on
the second line.
c) Line three identifies whether or not probe frequency
correction (PROBE CORRECTION) was used during
the survey. Probe correction can be in the form of a
frequency that was entered or a numeric correction
factor.