NARDA 8718B - Manual (Page 55)

54 Operating the Meter
To begin another logging run at a different rate or for a
different duration...
• Press F3 (MENU). Press the number 1 on the keypad
to select DATA LOG from the First Menu Screen and
proceed as previously described.
To end logging altogether and return to the standard
measurement screen...
• Press F4 (QUIT). To initiate logging again at a later
point, use the menu system to select DATA LOG from
the First Menu Screen.
N E W L O G G I N G R U N :
E N T E N E W F R N O . _ _
O K C L R M E N U Q U I T
F1 F2 F3 F4
R E
10. A screen will appear requesting that you assign
another two digit survey number to the new logging
run. Use the numeric keypad to enter the two-digit
number and then press F1 (OK) or ENTER. Again,
make note of the number for later use. If you make a
mistake, press F2 (CLR) to clear the screen and enter
a new survey number. The meter will automatically
return to the logged measurements screen.
Memory Capacity
To determine the remaining memory of the 8718B meter...
1. Access the menu system by pressing the function key
that corresponds to the legend below MENU on the
bottom line of the display.
2. Press the number 1 on the keypad to select DATA
LOG from the First Menu Screen.