Menu commands – NARDA 8718B User Manual
Page 33
32
Operating the Meter
Menu Commands
The following is a list of menu commands that are shown on the
fourth line of the display and selected by using the four function
keys (F1-F4).
AUTO
Auto – returns the meter to the normal,
automatic temperature correction mode.
ABORT
Abort clearing the memory
BEGIN
Begin – confirms that the meter is ready to
perform time averaging to meet the requirements
of a specific standard.
CABLE
Cable – changes the meter input from fiber optic
receiver to the standard cable input.
CANCEL
Cancel making the selection and return to the
previous menu.
CONT
Continuous – initiate logging for an undefined
interval.
CLEAR
Clear the memory of logged data.
CLR
Clear the screen and return to making real time
measurements.
DISCARD Discard this data point without storing it.
END
End the logging run or averaging interval.
FO
Fiber Optic – changes the meter input from the
standard cable input to the fiber optic receiver.
FREQ
Frequency – change or enter a frequency.
GHz
GHz – used to enter a frequency.
HR
Hours – used to define a logging interval.
kHz
kHz – used to enter a frequency.
LEFT
Left – set menus for left-handed operation.
LOG
Log the current measured value.