NARDA 8718B - Manual (Page 48)

47 Chapter 8 Data Logging
6. A screen will appear that indicates the value of reading
that has been temporarily stored in memory and the
number of the data point. The first data point will be 001.
7. Press F1 (SAVE) to permanently log this data point into
the meter’s memory with its associated data point
number. The meter will automatically return to the
measurement mode.
8. Press F3 (DISCARD) to erase the data point from the
meter’s temporary memory. The meter will
automatically return to the measurement mode.
9. Press F1 (LOG) again to log the second data point. It
will automatically be assigned data point 002 providing
that you had saved the first data point. If you had
elected to discard the first data point, then this point
will be designated data point 001.
10. Press either F1 (SAVE) or F3 (DISCARD). The meter
will automatically return to the logged measurements
screen.
11. Continue to record up to 999 data points in this manner.
12. To end this logging run and begin a new run,
press F3 (END). The screen will appear that allows
you to enter another two-digit survey number.
D A T A P O I N T N O . 0 0 1
1 2 . 1 % S T D
S A V E D I S C A R D
F1 F2 F3 F4
N E W L O G G I N G R U N :
E N T E N E W F R N O . _ _
O K C L R M E N U Q U I T
F1 F2 F3 F4
R E