NARDA 8718B - Manual (Page 23)

22 Operating the Meter
4. Change the units (if needed) by pressing either
F1 (kHz), F2 (MHz), or F3 (GHz).
5. Press F4 (SAVE). The probe correction factor will be
displayed briefly if you are using a probe in memory
and you will automatically return to the measurement
screen. See Using Probe Correction Factors on page 24.
6. From the Main Measurement Screen press F1(ALT) to
select the Alternate Measurement Display Screen.
To return to the Main Measurements Display Screen...
1. From the Alternate Measurement Display Screen, press
F1 (MAIN) to select the Main Measurements Display
Screen.
N
ote
Alternate values can-
not be calculated at
low frequencies for
standards with very
high magnetic field
limits. A “greater
than” symbol (>) is
shown under these
conditions.