NARDA 8718B User Manual
Page 34
33
Chapter 5
Using the Menu System
MAIN
Main – switch to the Main Measurement Display
Screen.
MAXR
Maximum Reset - reset the maximum value to
the instantaneous value.
MEASURE Measure – begin the measurement process by
selecting and zeroing the probe.
MEM
Memory – display the available memory.
MENU
Menu – access the First Menu Screen.
MIN
Minutes – used to define a logging interval.
MHz
MHz – used to enter a frequency.
NO
No – the current probe selection is incorrect.
Return to the menu to make another selection.
OFF
Off – turn special mode off.
OK
OK – continue with the same setting.
ON
On – turn special mode on.
PAUSE
Pause during data logging or time averaging.
QUIT
Quit special mode and return to the standard
measurement screen.
RESTART Restart the probe selection and zeroing process.
RGT
Right – set menus for right-handed operation.
SAVE
Save the data point or the new setting.
SEC
Seconds – used to define a logging interval.
SET
Set the time, date, temperature, or display
contrast.
START
Start averaging or data logging.
STNDS
Standards – access the menu of available
exposure standards.
STOP
Stop the current averaging run.
YES
Yes – the current probe selection is correct.
Proceed with zeroing process.