NARDA 8718B - Manual (Page 52)

51 Chapter 8 Data Logging
15. To end this logging run and begin a new run, press F3
(END). The screen will appear that allows you to enter
another two-digit survey number.
16. Use the numeric keypad to enter a new two-digit
survey number and then press F1 (OK) or ENTER.
Again, make note of this number so that you can later
associate this survey number with the data points
collected. If you make a mistake, press F2 (CLR) to
clear the screen and enter a new survey number.
The meter will automatically return to the
logged-measurements screen.
17. To end logging altogether and return to the standard
measurement screen, press F4 (QUIT). To initiate
logging again at a later point, use the menu system to
select DATA LOG from the First Menu Screen.
N E W L O G G I N G R U N :
E N T E N E W F R N O . _ _
O K C L R M E N U Q U I T
F1 F2 F3 F4
R E
Mode 3 Logging
To initiate Mode 3 logging (a series of data points
automatically logged at specific intervals)...
1. From the main data logging screen, press the
number 3 on the keypad to select CONTINUOUS
LOGGING from the logging menu screen.
1 L O G W I T H R E F #
2 L O G A V G W I T H R E F #
3 C O N T I N U O U S L O G G I N G
M E M Q U I T
F1 F2 F3 F4