ARRI ARRIFLEX 235 - Manual (Page 16)

16 16
4.3 Riser Plate
To use the ARRIFLEX 235 together with a bridge plate on a
tripod, it is necessary to bring the camera into the correct
position to the support rods. To do this, a riser plate is
mounted to the bottom of the camera onto which the
bridgeplate can be mounted.
Attaching the Riser Plate
• Fasten the riser plate with the two mounting screws
➪
photo using a 5mm allen key. Both cylindrical pins
must glide into the holes of the camera bottom.
4.4 Bridge Plates BP-8, BP-9
The bridge plates facilitate balancing of the camera on the
tripod and mounting of accessories. The BP-8 is designed
for 19 mm support rods, the BP-9 for 15 mm support rods.
The bridge plates consist of the base plate ➪
photo , the
sliding upper plate ➪ photo and a pair of support rods
➪ photo . In the standard version the support rods are
440mm long. Optionally, support rods are available in
the lengths 240mm and 340mm.
base plate
support rods
mounting screws
sliding upper plate
Installation