ARRI ARRIFLEX 235 - Manual (Page 59)

59 59
Setting the Film Counter Configuration (Mode 3)
The display configuration can be set individually.
The two shown combinations are possible:
The desired display configuration can be set in Mode 3:
• Change from Mode 1 to Mode 3 by depressing the
“MODE”-button twice.
• Depress the “SEL”-button twice; the first digit in the
upper display line blinks.
• Within three seconds, depress the “SET”-button.
• The currently set counting value of Mode 3 is displayed.
The corresponding counting value in Mode 1 is auto-
matically altered.
Resetting the Film Counter (Modes 1 and 3)
• Change to the mode which shows the total amount of
exposed film (“MODE”-button).
• The total exposed film counter can be set to zero by
depressing the “SET”-button (for at least 1.5 seconds)
while in standby.
• The take length counter is automatically reset each time
the camera is started.
Changing the Unit of Measurement (Meters/Feet) (Mode 3)
• Change from Mode 1 to Mode 3 by depressing the
“MODE”-button twice.
• Depress the “SEL”-button once; the symbol m/ft blinks.
• Depress the “SET”-button within three seconds to
change the unit of measurement.
Displaying the Angle of the Mirror Shutter
(Mode 1)
• As long as the “PHASE”-button is depressed while in
standby, the set angle of the mirror shutter appears in
the upper display line.
The camera runs at inching speed.
Setting the shutter angle: see Chapter 7.
Camera Operation